200 Paper Jam Messages - Lexmark M5150 Service Manual

200 paper jam messages

Error code Description
200.01 Media remains on the sensor (input) during
the warm‑up sequence.
200.02 Media reached the sensor (input) sooner
than the specified time. The wrong config ID
causes the engine to assume a 550 paper
path on a 250 model.
200.03 Media is late reaching the sensor (input)
within the specified time.
200.05 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = MPF tray)
200.07 Media reached the sensor (input) but did not
clear it within the specified time.
200.08 Media is late reaching the sensor (input)
within the specified time.
200.09 The proper main motor feedback to start
laser servo was not received.
200.10 Printhead motor was not locked when page
reached the sensor (input).
200.11 Printhead motor fell out of lock after the
page reached the sensor (input).
200.12 Printhead was not ready for the page when
the sensor (input) was reached.
200.13 The page at the sensor (input) is not the next
page to be imaged.
200.14 Proper main motor feedback to start laser
servo was not received.
200.15 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 1)
200.16 Main drive motor stalled.
200.17 Fuser motor stalled.
200.19 Paper never reached the sensor (input), but
it was successfully picked from the source.
200.25 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 2)
200.32 Detected sensor (control panel interlock)
bounce.
Action
Go to "Sensor (input) static jam service check" on page
Go to "Sensor (input) early arriving jam service check" on
page 71.
Go to "Sensor (input) never‑ or late‑arriving jam service check"
on page 72.
Go to "Sensor (input) late-leaving or did-not-clear jam service
check" on page 74.
Go to "Sensor (input) late-leaving or did-not-clear jam service
check" on page 74.
Go to "Sensor (input) never‑ or late‑arriving jam service check"
on page 72.
Go to "Main drive motor control jam service check" on
page 75.
Go to "Printhead motor control jam service check" on
page 76.
Go to "Printhead motor control jam service check" on
page 76.
Go to "Printhead motor control jam service check" on
page 76.
Go to "Sensor (input) miscellaneous jam 1 service check" on
page 76.
Go to "Main drive motor control jam service check" on
page 75.
Go to "Sensor (input) late-leaving or did-not-clear jam service
check" on page 74.
Go to "Main drive motor control jam service check" on
page 75.
Go to "Fuser drive motor control jam service check" on
page 76.
Go to "Sensor (input) miscellaneous jam 1 service check" on
page 76.
Go to "Sensor (input) late-leaving or did-not-clear jam service
check" on page 74.
Go to "Sensor (input) miscellaneous jam 2 service check" on
page 77.
Diagnostic information
69
4063
70.