Fuser Removal; Rear Door Removal - Lexmark M5150 Service Manual

9
Disconnect the cable (B) from the control board.
Installation note: When replacing the duplex motor, make sure the drive belt connected to the duplex is
properly reattached.

Fuser removal

CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
1
Remove the rear door. See
2
Open and lower the fuser access door.
"Rear door removal" on page
Repair information
456.
459
4063