Staple, Hole Punch Top Cover Removal - Lexmark M5150 Service Manual

3
Release the latches holding the sensor (B) to the cover.
4
Disconnect the cable from the stapler controller PCBA, then remove the sensor (finisher bin media present).

Staple, hole punch top cover removal

1
Remove the finisher left cover. See
2
Remove the finisher right cover. See
3
Remove the two screws (A) from the right side of the finisher.
"Staple, hole punch left cover removal" on page
"Staple, hole punch right cover removal" on page
Repair information
762
4063
739.
741.