Finisher Bin Media Present Error Service Check - Lexmark M5150 Service Manual

Finisher bin media present error service check

Action
Step 1
Is the staple finisher the only output option installed?
Step 2
Remove all output options and re-install only the staple finisher.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Step 3
Check the auto connector end of the option previously installed below the
staple finisher.
Is it free of damage?
Step 4
Check the lower interface cable. If damaged, then replace the lower
interface cable. See "Stapler lower interface cable removal" on
page 661.
Reseat the cable (J15) on the controller PCBA, then POR the machine.
Does the error remain?
Step 5
Open the left and top covers. Check the stapler output bin LED. If
damaged, then replace the bin LED. See
on page 658.
Reseat the cable (J21) on the controller PCBA and reseat the connector
on the bin LED end. POR the machine.
Does the error remain?
Step 6
Reseat the cable (J12) on the controller PCBA, then POR the machine.
Does the error remain?
"Stapler output bin LED removal"
Diagnostic information
307
Yes No
Go to step 4. Go to step 2.
The problem may not Go to step 3.
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Go to step 4. Replace the upper
interface cable of the
output option
previously installed
under the staple
finisher.
Go to step 5. The problem is solved.
Go to step 6. The problem is solved.
Go to step 7. The problem is solved.
4063