Hcoe Main Motor Jam Service Check - Lexmark M5150 Service Manual

Action
Step 14
a
Check the belt tensioner for damage.
b
Make sure the tensioner spring is aligned and properly seated.
c
Check if there is no problem with the tension of the spring.
Is the belt tensioner functional and free of damage?
Step 15
Reseat all connectors on the controller PCBA, then POR the machine.
Does the error remain?

HCOE main motor jam service check

Action
Step 1
a
POR the machine.
b
Reseat the output option on the printer.
c
Clear obstructions along the paper path.
d
Make sure the sensors (pass through) are free from obstruction.
e
Close the rear door properly.
Does the error remain?
Step 2
Is the high capacity output expander the only output option installed?
Step 3
Remove all output options and re-install only the high capacity output
expander.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Yes
If the error persists,
then go to step 15.
Replace the controller
PCBA. See
controller PCBA
removal" on page
591.
If the error persists,
then replace the HCOE.
See
output expander
option removal" on
page
Yes
Go to step 2.
Go to step 4.
The problem may not
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Diagnostic information
156
No
Replace the HCOE belt
tensioner. See
belt tensioner
removal" on page
601.
The problem is solved.
"HCOE
"High capacity
584.
No
The problem is solved.
Go to step 3.
Go to step 4.
4063
"HCOE