Data Security Notice; Tools Required For Service - Lexmark M5150 Service Manual

Paper type Paper weight
Rough/cotton
60–90 g/m
(16–24 lb)
Custom type [x]
60–90 g/m
(16–24 lb)
*
The finisher stacks the paper but does not staple or punch holes in it.

Data security notice

1
This printer contains various types of memory that are capable of storing device and network settings, information
from embedded solutions, and user data. The types of memory, along with the types of data stored by each, are
described below.
•
Volatile memory—This device utilizes standard Random Access Memory (RAM) to temporarily buffer user data
during simple print and copy jobs.
•
Non-volatile memory—This device may utilize two forms of non-volatile memory: EEPROM and NAND (flash
memory). Both types are used to store the operating system, device settings, network information, scanner and
bookmark settings, and embedded solutions.
• Hard disk memory—Some devices have a hard disk drive installed. The printer hard disk is designed for device-
specific functionality and cannot be used for long term storage for data that is not print-related. The hard disk
does not provide the capability for users to extract information, create folders, create disk or network file shares,
or transfer FTP information directly from a client device. The hard disk can retain buffered user data from
complex print jobs, as well as form data and font data.
To erase volatile memory, turn off the printer.
To erase non-volatile memory, see the menu item under
To erase the printer hard disk, see the menu item under
The following parts are capable of storing memory:
• printer control panel
•
UICC (User Interface Controller Card)
•
controller board
• optional hard drives
Note: The printer control panel and controller board contain NVRAM.
2
After removing the old part, it must be returned to your next level of support.

Tools required for service

•
Flat-blade screwdrivers, various sizes
•
#1 Phillips screwdriver, magnetic
•
#2 Phillips screwdriver, magnetic
•
#2 Phillips screwdriver, magnetic short-blade
•
7/32 inch (5.5 mm) open-end wrench
4‑bin mailbox
2
2
General information
51
Offset stacker Staple finisher
"Configuration menu" on page 340
"Configuration menu" on page 340
4063
Staple, hole punch
finisher
pertaining to this.
pertaining to this.