Finisher Tests; Staple Test; Hole Punch Test; Feed Test - Lexmark M5150 Service Manual

To run the Diverter Test:
1
From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Diverter Test.
Diverter Test Testing... appears while the printer is verifying the state of the diverter.
2
Press X to exit the test.

FINISHER TESTS

Staple Test

This test verifies the operation of the staple mechanism in the finisher. The printer feeds eight pieces of media to the
finisher and accumulates all eight pieces in the finisher. After the last sheets are accumulated, the pack is stapled.
1
Enter Diagnostics menu, and then select FINISHER TESTS.
2
Select Staple Test.
Staple Test Running... appears while the test is running.

Hole Punch Test

This test verifies that media can be fed to the finisher output bin and then hole punched. The printer feeds eight pieces
of blank media to the finisher and then the pages are hole‑punched with a 2‑hole, 3‑hole, or 4‑hole pattern, depending
on the selected punch test.
To run this test:
1
From the Diagnostics menu, navigate to:
Finisher Tests > Hole Punch Test
2
Select one of the following:
•
2 Punch Test
•
3 Punch Test
• 4 Punch Test
Hole Punch Test Running... appears while the test is running.

Feed Test

This test verifies that media can be fed from the default source to a finisher bin. Any paper size that is supported can
be used. The printer feeds one blank sheet of media from the default paper source to the finisher bin.
1
Enter Diagnostics menu, and then select FINISHER TESTS.
2
Select Feed Test.
Feed Tests Running... appears while the test is running.
Service menus
332
4063