Finisher Bin Error Service Check - Lexmark M5150 Service Manual

Action
Step 4
Check the lower interface cable. If damaged, then replace the lower
interface cable. Go to "Stapler lower interface cable removal" on
page 661.
Remove the left cover. Reseat the cable (J15) on the controller PCBA, then
POR the machine.
Does the error remain?
Step 5
Open the left cover. Reseat the cables (J18 and J15) on the controller PCBA,
then POR the machine.
Does the error remain?
Step 6
Open the left cover, reseat all connectors on the controller PCBA and then
POR the machine.
Does the error remain?

Finisher bin error service check

Action
Step 1
Is the staple finisher the only output option installed?
Step 2
Remove all output options and re-install only the staple finisher.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Step 3
Check the auto connector end of the option previously installed below the
staple finisher.
Is it free of damage?
Yes
Go to step 5.
Go to step 6.
Replace the controller
PCBA. Go to
finisher option
removal" on page
621.
If the error persists,
then replace the staple
finisher. Go to
finisher option
removal" on page
621.
Yes
Go to step 4.
Perform step 2 again
using the other
remaining output bins.
Go to step 4.
Diagnostic information
302
No
The problem is solved.
The problem is solved.
The problem is solved.
"Staple
"Staple
No
Go to step 2.
Go to step 3.
Replace the upper
interface cable of the
output option
previously installed
under the staple
finisher.
4063