Finisher Tray Holder Jam Service Check - Lexmark M5150 Service Manual

Action
Step 9
Open the left cover, reseat all connectors on the controller PCBA and then
POR the machine.
Does the error remain?

Finisher tray holder jam service check

Action
Step 1
a
POR the printer.
b
Reseat all the installed output options on the printer.
c
Clear obstructions along the paper path.
d
Make sure that the sensors (pass through) are free from obstructions.
e
Close the rear door properly.
Does the error remain?
Step 2
Is the staple finisher the only output option installed?
Step 3
Remove all output options and re-install only the staple finisher.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Step 4
Check the auto connector end of the option previously installed below the
staple finisher.
Is it free of damage?
Yes
Replace the controller
PCBA. See
controller PCBA
removal" on page
663.
If the error persists,
then replace the staple
finisher. See
finisher option
removal" on page
621.
Yes
Go to step 2.
Go to step 5.
Perform step 3 again
using the other
remaining output bins.
The problem may not
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Go to step 5.
Diagnostic information
170
No
The problem is solved.
"Stapler
"Staple
No
The problem is solved.
Go to step 3.
Go to step 4.
Replace the upper
interface cable of the
output option
previously installed
under the staple
finisher.
4063