Staple, Hole Punch Lower Interface Cable Removal; Media Pusher Assembly Removal - Lexmark M5150 Service Manual

Staple, hole punch lower interface cable removal

1
Remove the finisher left cover. See
2
Unplug the connector (J15) from the stapler controller PCBA.
3
From the bottom of the finisher, release the latches, and then push connector off its slot.
4
Remove the interface cable.

Media pusher assembly removal

1
Remove the finisher left cover. See
2
Disconnect the cable J17 from the stapler controller PCBA.
"Staple, hole punch left cover removal" on page
"Staple, hole punch left cover removal" on page
Repair information
759
4063
739.
739.