Entering recovery mode
This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer. Code
can be flashed from a PC by USB.
1
Turn off the printer.
2
Press and hold the 7, 2, and 8 buttons simultaneously.
3
Turn on the printer.
4
Release the buttons after 10 seconds.
Accessing the Network SE menu
This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1
Navigate to:
Networks/Ports > Standard Network > Std Network Setup.
2
Press and hold the 6, 7, and 9 simultaneously.
Service Engineer menu
•
"Accessing the service engineer (SE) menu" on page 352
•
"Service engineer (SE) menu" on page 352
Accessing the service engineer (SE) menu
From a Web browser on a host PC, add /se to the printer IP address.
Service engineer (SE) menu
This menu should be used as directed by the next level of support.
Top‑level menu
Intermediate menu
Print SE Menus
General
Copyright — Displays copyright information
Code
History
•
Network code level — Displays network code level
•
Network Compile Info — Displays network compile information
•
Printer Code Level — Displays printer code information
•
Printer Compile Info — Displays compile information
•
Print History
•
Mark History
•
History Mode
Service menus
352
4063