Sensor (Hcit Media Low) With Flag Removal - Lexmark M5150 Service Manual

4
Crimp both connector pins (A) using pliers to make them fit through the pin holes. Push the connector off its slot.
5
Route the interface cable off the drawer, and remove.
Note: Pay attention to the original routing of the cable.

Sensor (HCIT media low) with flag removal

1
Remove the HCIT. See
2
Remove the HCIT rear cover. See
3
Remove the HCIT left cover. See
4
Release the latches (A) securing the sensor to the drawer.
"HCIT removal" on page 531.
"HCIT rear cover removal" on page
"HCIT left cover removal" on page
Repair information
536.
537.
547
4063