Table of Contents
Advertisement
4 Fax
Print
Prints the selected file.
On-hook (Confirming Remote Machine Response Prior to Transmission)
Use this feature when using Manual Send.
Manual Send is the transmission method that allows you to send a fax after you make
a phone call to a remote machine and then check that the connection is established.
This feature can be used with the receiver either off-hook or on-hook.
We recommend that you set the line monitor volume to "Loud".
Note
You can change the volume of the line monitor in the System Administration mode. For information on
how to change the volume, refer to "5 Tools" > "Common Service Settings" > "Audio Tones" > "Line
Monitor Volume" in the Administrator Guide.
1
Pick up the telephone receiver, or select
[On-hook (Manual Send/Receive)].
4
2
Select any option.
Manual Receive/Manual Send
Use the drop-down menu to switch between [Manual Send] and [Manual Receive].
Manual Send
Manual Receive
Entering a destination
Use alphanumeric characters to specify a destination.
Note
More Characters
Select this button to display a symbol screen, allowing you to use symbols to specify a
destination.
Line Cut
Cuts the line connected.
212
• If an error occurs during transmission of, for example, the second page, the transmission of
the first page may also end abnormally.
• On-hook feature is not available in the IP Fax (SIP).
: Allows you to check if connection is established before
sending a fax.
: Allows you to receive a fax manually, such as Facsimile
Information Services.
• Some touch-tone services may not be available even if you set your telephone to send tones.
• When the line type is set to a tone line, [:] (Tone) is not displayed on the screen. If you want
to send tones (or to use the touch-tone services) while using a pulse line, select [:] (Tone).
Advertisement
Table of Contents
