Table of Contents
Advertisement
Original Orientation
Allows you to specify the orientation of the document so that the machine can identify
the top of the document.
Note
• If the [Original Orientation] setting differs from the actual document orientation, the machine
Upright Images
Select this option when placing the top edge of the document against the top side of
the document glass or document feeder.
Sideways Images
Select this option when placing the top edge of the document against the left side of
the document glass or document feeder.
Output/Offset
Allows you to select the output destination tray and offset operation.
Offset Stacking
This option is displayed when you select [Center Tray - Lower] for the output
destination. When an optional finisher is installed, this option is displayed when you
select [Right Middle Tray].
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations. You can select from [Offset per Set], [Offset per
Job], [Offset Every N Pages], [Offset Every N Sets], and [System Default].
Note
• This feature does not appear for some models. An optional component is required. For more
• If you select [System Default], the setting in the System Administration mode will be
Paper Size and Stapling Position
Finisher-A1
,
A4
B5 ,
×
7.25
10.5" ,
×
8.5
11"
16K
A4, A3, B4,
×
8.5
11",
×
,
8.5
13"
×
8.5
14",
×
11
17", 8K
may not detect the top of the document correctly.
information, contact our Customer Support Center.
effective. For information on how to change the setting, refer to "5 Tools" > "Copy Service
Settings" > "Copy Defaults" > "Output Destination" in the Administrator Guide.
1 Staple
1 Staple
(Left)
(Right)
,
Output Format
3
127
Advertisement
Table of Contents
