Automatic Document Feeder - Sharp MX-3070N User Manual

BEFORE USING THE MACHINE►HOW TO PLACE THE ORIGINAL

AUTOMATIC DOCUMENT FEEDER

This section explains how to place originals in the automatic document feeder.
• Place originals of different sizes together, if needed, in the automatic document feeder. In that case, use the "Others"
function in each mode to set mixed size originals. An original cannot be detected if all pages are of the same size but some
of them are set in a different orientation.
B5 (5-1/2" x 8-1/2")
A4 (8-1/2" x 11")
• Before inserting originals into the document feeder tray, be sure to remove any staples or paper clips.
• If originals have damp spots due to correction fluid, ink or pasteup glue, wait until the originals are dry before making
copies. Otherwise the interior of the machine or the document glass may be soiled.
• Do not use the following originals. Incorrect original size detection, original misfeeds, and smudges may result.
Transparency film or other transparent material for backup copy, tracing paper, carbon paper, thermal paper or originals
printed with thermal transfer ink ribbon should not be fed through the document feeder. Originals to be fed through the
feeder should not be damaged, crumpled, folded, loosely pasted together, or have cut-out holes. Originals with multiple
punched holes other than two-hole or three-hole punched paper may not feed correctly. A document(thermal transfer
paper, etc.) printed using an ink ribbon (thermal transfer printing)
• When using originals with two or three holes, place them so that the punched edge is at a position away from the feed slot
of the document feeder tray. Specify the orientation of the original using [Original].
Feed slot
• For a thin original (9 lbs. to 14 lbs. (35 g/m
2-sided scanning is disabled.
Hole positions
2 2
- 49 g/m )), use [Slow Scan Mode] in the "Other Functions". For this type,
1-67