Network Name Setting; Protocol Settings - Sharp MX-3070N User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS
PIN Code/Password
Enter the password.
Change PIN Code
To change the password, set
Authentication
Select the authentication server from the drop-down list.
KDC Server
Enter the IP address or host name of the Kerberos authentication server.
Realm
Enter the Kerberos realm.
Enable SSL
If is set, the SSL encryption communication is enabled.
Connection Test
Tap the [Execute] button to test the connection to the LDAP server.
Public Folder / NAS Setting
Set each option to [Prohibited] if the storage is not used.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine, see
"TURNING ON THE POWER (page

Network Name Setting

Device Name
Enter a device name.
Domain Name
Enter the domain name.
Comment
Enter a comment.

Protocol Settings

Select the general network settings.
The TCP/IP, NetWare, EtherTalk, and NetBIOS status information can be set.
TCP/IP
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine.
DHCP
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol) v6.
When this setting is enabled, it is not necessary to manually enter an IP address.
If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes,
printing will not be possible.
.
1-10)".
7-134