Table of Contents
Advertisement
Removing SCSI HDDs
To avoid equipment damage, review the precautions
described in "Before you start" on page 19 before removing
a SCSI device.
To remove a SCSI hard disk drive from a 3.5-inch device bay,
follow the instructions in "Removing IDE HDDs" on page 42.
To remove a SCSI hard disk drive from a 5.25-inch device bay:
1
Remove the bezel and side panel. For instructions, see
"Removing and installing the bezel and side panel" on
page 24.
2
Remove the two screws that secure the SCSI drive and metal
fittings, then partially extract the SCSI drive.
3
Disconnect the power cable and the SCSI cable from the
drive.
4
Remove the SCSI HDD.
5
Install the shield cover and secure it with screws.
6
Install the blank panel in the empty slot in the bezel.
7
Reinstall the side panel and bezel. For instructions, see
"Removing and installing the bezel and side panel" on
page 24.
Connecting Components
Adding a SCSI hard disk drive
49
Advertisement
Table of Contents
