Table of Contents
Advertisement
42
Connecting Components
Adding an IDE hard disk drive
10 Reconnect the power and signal cables to the hard disk and
floppy disk drives.
11 Reinstall the side panel and bezel. For instructions, see
"Removing and installing the bezel and side panel" on
page 24.
Removing IDE HDDs
1
Remove the bezel and side panel. For instructions, see
"Removing and installing the bezel and side panel" on
page 24.
2
Remove the power and signal cable from the hard disk and
floppy disk drives.
3
Remove the two screws securing the drive carrier.
4
Press the latches on the sides of the drive carrier, then slide the
carrier out of the server chassis.
CAUTION: When removing the drive carrier, be careful not to
tangle system cables or touch the memory board.
5
Remove the two screws securing the hard disk drive to the
drive carrier, then slide the drive from the carrier. Save the
screws for future use.
6
Install the 3.5-inch shield cover.
7
Insert the drive carrier in the server chassis and secure it with
two screws.
8
Connect the power and signal cables to the floppy disk drive
and any remaining hard disk drive.
9
Reinstall the side panel and bezel. For instructions, see
"Removing and installing the bezel and side panel" on
page 24.
Advertisement
Table of Contents
