Table of Contents
Advertisement
If the server is in use, shut it down and unplug the power
1
cable.
WARNING: Installing a CPU module with the power on could
result in electrical shock, and damage the CPU and/or
server.
To avoid burn injuries, never install a CPU module
immediately after turning off the server. Wait until the heat
around the CPU slot dissipates.
CAUTION: CPU modules can be seriously damaged by static
electricity. Wear a wrist or heel ground cable to discharge
static electricity carried on your body. If such equipment is
not available, touch a grounded metal object to discharge
static electricity before working on sensitive electronic
components.
1
Remove the bezel and side panel. For instructions, see
"Removing and installing the bezel and side panel" on
page 24.
2
Disconnect the fan cable attached to the CPU module you are
going to remove from the system board.
3
Press the tabs on the CPU slot outward to release the CPU
module, then lift and remove the module.
Connecting Components
Adding a secondary CPU module
31
Advertisement
Table of Contents
