Set the SCSI-ID for the hard disk drive. For instructions, see
2
"Jumper settings for SCSI HDDs" on page 45.
3
Position the rails on the SCSI hard disk drive and secure them
with four screws.
4
Remove the screws securing the 5.25-inch shield cover and
store the cover in a safe place.
Removing the shield
5
Insert the SCSI HDD into the slot and secure it with two
screws.
Inserting the SCSI hard disk drive
6
Connect the power and SCSI cable to the SCSI HDD.
Connecting Components
Adding a SCSI hard disk drive
47