Table of Contents
Advertisement
40-pin IDE
connector
Jumper shunt
Drive ID jumper setting for Western Digital IDE hard disk drives
When adding IDE devices, set the devices according to the
following table:
To add a second (slave) device to the secondary IDE interface you
will need to purchase a new cable with an additional connector for
connecting the slave device.
Primary IDE interface
Master
HDD
connected.
Installing IDE HDDs
1
Remove the bezel and side panel. For instructions, see
"Removing and installing the bezel and side panel" on
page 24.
2
Disconnect the power and signal cables from the hard disk
and floppy disk drives.
3
Remove the two screws securing the drive carrier.
Connecting Components
Adding an IDE hard disk drive
10-pin drive J8 jumper settings
9 7 5 3 1
Single(Standard installation)
10 8 6 4 2
9 7 5 3 1
Dual (Master)
10 8 6 4 2
9 7 5 3 1
Dual (Slave)
10 8 6 4 2
J8 Jumper block
Power connector
Slave
First additional
HDD
connected.
Secondary IDE interface
Master
CD-ROM drive
connected.
39
Slave
Second
additional HDD
connected.
Advertisement
Table of Contents
