Table of Contents
Advertisement
116
If Something Goes Wrong
Hardware Diagnostic Program
Select the desired subtest number from the subtest menu and press
. This message will appear:
Enter
[TEST PARAMETER]
01. Go to Test
02. Test Loop
03. Error Stop
TECHNICAL NOTE: Each diagnostic test item has a different
set of test parameters.
01. Go To Test
02. Test Loop
03. Error Stop
: NO
: YES
Starting the test. If you need to stop the test
program, press
Selecting YES increments the pass counter each
time the test cycle ends and restarts the test cycle.
Selecting NO returns from the subtest menu to
the main menu after the test is complete.
Selecting YES stops the test program when an
error is detected.
Selecting NO keeps the test running even if an
error is detected.
Ctrl
+
Break
.
Advertisement
Table of Contents
