Toshiba M500D User Manual page 56

38
Connecting Components
Adding an IDE hard disk drive
IDE interface locations on the system board
Drive ID jumper setting for IDE HDDs
To connect an additional HDD to the IDE interface, you must set
each drive as either master or slave. The settings for Fujitsu and
Western Digital hard disk drives are shown below.
40-pin IDE
connector
Jumper shunt
Drive ID jumper setting for Fujitsu IDE hard disk drives
Primary IDE interface
Secondary IDE interface
9-pin drive jumper settings
9 7 5 3 1
Single & Dual (Master)
(Standard installation)
8 6 4 2
9 7 5 3 1
Dual (Slave)
8 6 4 2
Jumper block
Power connector