Throttle Mechanism; Disassembling Advancer Arm - TOHATSU TLDI 40 Service Manual

5) Throttle Machanism

Disassembling Advancer Arm

Disassemble the following components.
q Throttle link rod
w TPS* link rod
e Oil pump link rod
* TPS: abbreviation for throttle position sensor
Prior to removing q, w and e it will be necessary
to disconnect the rod snaps from the advancer arm.
Take care not to apply any force to the corresponding
arm when disconnecting the ball joint.
r Bolt: type H635, including washers and collar
t Advancer arm
Inspect the following components.
q Throttle link rod
w TPS link rod
e Oil pump link rod
• Check ball joint cap for wear and damage.
• Check for bent link rods.
Inspect the following components.
Throttle link rod snap
TPS link rod snap
Oil pump link rod snap
Check for wear and damage.
r
t
e
w
4-31
q