Removing Power Unit - TOHATSU TLDI 40 Service Manual

1) Removing Power Unit

Disassemble the following components.
Fuel connector
Battery
Ring gear cover
r Battery cable
Disassemble the following components.
Begin by disassembling the oil tank; then remove the 3
connectors from the power trim and tilt (PT&T) switch.
t Oil tank mounting bolts
y PT&T switch cable connectors
Fuel hose (remove from strainer inlet)
P Type
Disassemble the following components.
i Wire harness connectors: 3
o Throttle cable from advancer arm
!0 Gearshift cable from gearshift arm
!2 Water hose from compressor
Ground connector from cylinder
F Type
Disassemble the following components.
i Wire harness connectors: 3
Neutral switch cable
o Throttle cable from advancer arm and cable bracket.
!0 Gearshift rod from gearshift lever
!1 "S"-shape link from throttle stop arm
!2 Water hose from compressor
Ground connector from cylinder
!2
i
o
!1
4-3
r
t
y
!0