Installing Gearshift Lever Assembly - TOHATSU TLDI 40 Service Manual

1. Installing Gearshift Lever Assembly

(1) Following the procedures illustrated in the figure below, apply grease to the designated locations and
install the gearshift lever on the lower cover.
Washer, 6.5-16-1.5 (3C8-66308-0)
Bolt (910103-6670)
Apply OBM grease here
(2) Adjust the pitch of the link rod by 141 mm
length has been adjusted, secure in place using the locknut.)
*Clamp 6.5 - 47.5P
Oil hose
Apply OBM grease here
R
• Use 3 gearshift lever stoppers
• Gearshift lever stopper plate not required
• Clamps should be tightened together
Gearshift lever (3T5-66110-0)
Gearshift leverB (3T5-66129-0)
Washer, 14-22-1
Seal ring,13.8-22-5
(3T5-67147-0)
Wave washer
(941403-0600)
Bushing,14-16.5-17.7 (350-67105-0)
( ) , and then link gearshift lever B to the shift arm. (Once the
*
R
N
F
Gearshift lever
install position
Lower cover
Washer, 6.5-16-1.5 (3C8-66308-0)
Nylon nut, 6P1.0 (930403-0600)
Apply OBM grease here
Lower cover
N
• Insert washers on both sides of gearshift lever B
and be sure to bend split pin over completely.
8-2
TLDI
50D2
F
Apply OBM grease here in