Installing Handle To Engine - TOHATSU TLDI 40 Service Manual

3. Installing Handle Assembly
(1) Install the switch box on the handle using the bolt (910103-6625).
(2) Position the cable holder so that one end is approximately 200 mm from the cable outlet of the cable
assembly C switch box; then press into place and secure to the steering bracket using the screws
(921903-0625).
• Position the span of cable between the switch box outlet and the cable holder 200 mm away so that it is
tucked against the underside of the steering handle holder.
• After installation, confirm that there is no excessive pulling or bending stress applied to the cable by
moving the handle up and down.
Cable holder

4. Installing Handle To Engine

(1) Pass the cable assembly C cable the battery cables together through the grommet (3T5-67162-0),
install handle bracket; then insert the grommet into lower cover.
(2) Connect cable assembly C to both cable assembly A and the neutral switch.
• Apply silicon grease to the plugs and seal surface of the neutral switch and connect.
• Secure cable assembly C and the oil hose together to the gearshift lever stopper to prevent them from
interfering with the gearshift mechanism.
8-4
Handle