Cooling Water Indicator; Battery Level Warning - TOHATSU TLDI 40 Service Manual

e Cooling Water Indicator
A water temperature warning is displayed and the
engine automatically reduces speed whenever the
cooling water rises above the designated level.
Sensor setting
No.
1 Threshold
Over threshold
2
Remedial Action:
Quickly move the boat to a safe harbor, set the
throttle grip or remote control lever to the low
speed range and set the gearshift or remote
control lever to the Neutral (N) position. Confirm
whether cooling water is discharged with sufficient
force from the water inspection hole; then turn off
the engine. Remove any trash or plastic material
from the vicinity of the gear case.
Remarks:
The following procedure is required to cancel the
engine regulation mode once it has been activated,
regardless of whether temperature has returned to
normal.
Table No. 1: lower to idling speed.
Table No. 2: turn off engine.
Remarks:
This warning applies to only to cooling water
temperature and is not related to fuel combustion
and lubrication oil related warnings.
r Battery Level Warning
• The battery warning indicator flashes when the
battery level falls below 10V. All 3 warning
indicators flash when battery voltage rises to
abnormally high levels.
• The battery warning indicator flashes and engine
speed is automatically reduced to the 2,800 to
3,200 rpm range when a battery fault occurs or
there are faulty battery cable connections. Note
that the engine will completely shut down in the
case of serious faults.
Remedial Action:
• Inspect and properly install battery connectors.
• Recharge battery.
• Replace battery.
Regulated rpm
2,800 to 3,200 rpm
700 to 900 rpm
11-11
Tachometer on EPTO series
3
2
1
0
Water warning indicator
Light warning indicator
Switchbox on EPTO and EPTO series
3 4
2
5
1 6
0
7
- +
4
5
6
7
-
+
Battey
warning
indicator