Adding Gear oil
Refer to section 5 (Inspecting Gear Case Area) of
Chapter 3 (Inspection and Maintenance) for detailed
description of gear oil replacement procedure.
Assembling Gear Case Assembly
• Apply a thin coating of the specified grease to the
spline area on the engine side of the drive shaft.
Grease Type: Nippeko LT-2
Install water pipe by first applying oil to the water
pipe seal rubber and sliding it through the rubber
seal.
Assemble by first installing bolts at the 2 locations on
the gear case marked with the ı ı then install the
remaining bolts.
Torque: 19 to 21 N-m: 1.9 to 2.1 kg-m: 14 to 15 Ib-ft
Spring pin
Special tool
Spring pin tool B
345-72228-0
Replace with new one.
*
6-12
ı ı mark