Disassembling Water Pump Case; Disassembling Propeller Shaft And Clutch - TOHATSU TLDI 40 Service Manual

Disassembling Water Pump Case

q Remove the lower section of the water pump case.
Remove by inserting a flathead screwdriver along
the case removal groove.

Disassembling Propeller Shaft and Clutch

Remove the various components using the following
procedures.
o Bolt: type H625 at 2 locations
i Propeller shaft housing (with q to u)
t Clutch pin snap ring
u Clutch pin
Press lightly on y in order to remove clutch pin u.
q Propeller shaft
w Bevel gear, C
e O-ring
r Clutch
t Clutch pin snap ring
y Push rod
i Propeller shaft housing
Take care when removing u as the push rod y,
chutch spring holder !0 and steel ball !2 are liable
to spring out.
Remove the following components.
r Clutch
y Push rod
!0 Clutch spring holder
!1 Clutch spring
!2 Steel ball
Replace with new pin
*
6-5
q
o
i
q
w
t r y
e
u
r
!0
y
!2
u
!1