Removing Harness Assembly - TOHATSU TLDI 40 Service Manual

Removing Harness Assembly

Remove the following components.
Remove harnesses in order starting from remote
control side.
r Water temperature connector
• Remove by pressing down on hook and pulling out
connector.
t Fuel injector connector
• Remove by pressing down on wire hook and pulling
out connector.
y Air injector connector
• Remove by pressing open the claws on either side
with a flathead screwdriver and pulling out.
u Bullet connectors for ignition coils
When removing cable assembly with the
compression head resting on the engine base, be
sure to remove the air rail bolt to free the air rail.
Remove the following components.
i FFP * connector
• Remove by pressing down on hook and pulling out
connector.
* FFP: abbreviation for fuel-feed pump.
o TPS * connector
• Remove by pressing down on hook and pulling out
connector.
* TPS: abbreviation for throttle position sensor.
r
t
u
4-8
i
o
y