Epto Series - TOHATSU TLDI 40 Service Manual

EPTO Series

r Insert the key in the switch.
Remarks:
The engine will not start unless the remote control
lever is in the Neutral position.
t Set the remote control lever to neutral.
Make sure that the neutral warm-up lever has been
set to fully closed position.
Remarks:
Prior to turning the main switch key to On, make
sure that the neutral warm-up lever has been set to
fully closed position.
Mistakenly turning the key to On with the neutral
warm-up lever open will result in the operational
error being recorded in the engine control unit
(ECU). Repeating this error will in turn result in the
3 warning indicators flashing simultaneously.
Should this occur, turn the main switch key to Off;
then move the neutral warm-up lever to fully closed
position and proceed to the next step.
y Turn the main switch key to On, when the beep
stops (after 1 or 2 seconds) turn it to Start and turn
over the engine.
u As soon as the engine starts, release the key.
The key will automatically return to its normal
position.
Remarks:
Turning the key to Start for a period of 1 second
during engine idling or trolling has the effect of
increasing engine speed. A beep sounds each
time and engine speed increases progressively in
the following increments.
700 * 800 * 900 * 800 * 700 * 800 * 900
rpm
11-9
Neutral (N)
Fully open
Fully closed
Neutral
warm-up lever
Main switch
key
Stop switch
ON
OFF
START
ON
OFF
START