Periodic Inspections - TOHATSU TLDI 40 Service Manual

1. Periodic Inspections

Inspection
points
High press.
Fuel filter
Piping
Fuel tank
Air filter
Drive belt
Fuel pressure
Air pressure
Spark plug
Starter motor
Battery
Propeller
Gear oil
Water pump
Oil tank
Oil pipes
Oil filters
Warning system
Nuts and bolts
Sliding & rotating parts,
grease nipples
Power trim & tilt
Anodes
Note: The manual recommends the engine be overhauled after every 300 hours of operation.
Inspection intervals
10 hrs. 30 hrs 50 hrs.
or or or
bimonthly monthly 3 months 6 months
Replace
100 hrs.
or Yearly 1.5 years
Replace
3-2
200 hrs. Inspection procedure
or
2 years
Replace
Wear on pipes &
Replace
leaking connectors
Clean
Replace
Replace
Remove carbon
Spark gap
Salt deposits &
battery cables
Mountings, fluid & spec,
gravity levels
Wear, bending &
chipping on blades;
slipping of cushion rubber
Replenish or change oil,
check for water leakage
Wear and cracks on
Replace
impeller & liner
Oil leaks, damage faulty
clip; wash filter
Tighten
Apply or inject grease
Check & replenish oil;
manually operate
Check for corrosion,
warping and wear
Remarks
Entire cartridge
Including filter
1.0 to 1.1 mm
(0.039 to 0.043 in)