Crankshaft Holder (3T5-72815-0) - TOHATSU TLDI 40 Service Manual

w Crankshaft Holder (3T5-72815-0)
Removing Pulley Nut
1. Disassemble the flywheel. (Refer to section q of this chapter.)
2. Install the magneto key and crankshaft holder for this engine.
3. Use the magneto nut to secure the crankshaft holder in place. (The magneto nut is threaded
clockwise.)
4. Using two 36 mm wrenches, attach one to the crankshaft holder and use the other to loosen the
pulley nut.
Installing Pulley Nut
1. Apply thread lock (Three Bond #1342) to the thread area.
2. Screw the pulley nut onto the crankshaft by hand.
3. Install the engine's magneto key; then install the crankshaft holder.
4. Use the magneto nut to secure the crankshaft holder in place.
5. Using two 36 mm wrenches, attach one to the crankshaft holder and use the other to tighten on the
pulley nut, adjusting it to the torque shown below.
Tightening Torque: 140 to 160 N-m (14 to 16 kg-m) = (102 to 116 Ib-ft)
Magneto nut
Magneto key
Crankshaft holder
3T5-72815-0
Pulley nut
Apply a thread lock agent to
the thread.
2-20