TOHATSU TLDI 40 Service Manual page 157

Symptom
9.
Poor
9-1.
acceleration
Electrical
at full throttle
control
or sudden
system
drop down to
idling speed
9-2.
Remote
control system
10.
Unable to
exceed
3000 rpm at
10-1.
full throttle or
Electrical
suddenly
control
drops and
system
stays at
3000 rpm
*1. TPS: abbreviation for throttle position sensor
FFP: abbreviation for fuel-feed pump (electric pump)
Lift pump: diaphragm type fuel pump
*2. TPS reset: TPS reset required under following conditions
q Indicates occurrence of TPS error due to remote control cable setup. Readjust cable.
w Indicates that TPS and/or ECU have been replaced.
e Indicates that the link or rod snap ring is replaced due to warpage or wear in linkage.
Refer to the section on self-diagnosis functions and reset the TPS to its initial values.
Item
Cooling water
temperature too high
(temp. indicator flashes)
Battery voltage
abnormally high (battery
indicator flashes)
TPS not functioning
Advancer arm not
functioning
Cooling water
temperature too high
(temp. indicator flashes)
Battery voltage
abnormally low (battery
indicator flashes)
TPS not functioning
Remote control
9-12
Self-
Warning
diagnosable
Beeps indicator
points
A (oil)
Continuous
Continuous
Flashing
Continuous
Continuous
Continuous
Continuous
Flashing
Warning Warning
indicator B indicator
(water temp) C (battery)
Flashing
Flashing
Flashing
Flashing
Flashing Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing