Reassembling Power Unit - TOHATSU TLDI 40 Service Manual

2) Reassembling Power Unit

Install the following components.
• Install the engine base gasket.
• Knock pin
Secure eyebolts to the flywheel; then use a sufficiently
strong hoist to suspend the power unit while keeping it
in the horizontal position.
With power unit suspended, install the following com-
ponents.
• Crankcase head
Apply a sufficient amount of heat-resistant grease
(LOR #101) to the entire circumference of the oil
seal lip.
Apply a sufficient amount of the recommended
grease to the O-rings.
Refer to servicing information (section 3 in chapter 2).
Place power unit on to engine base.
Take care that none of the wiring or hoses gets
caught between the power unit and engine base
mating faces.
Referring to section 1), assemble power unit in the
reverse order of the procedures described there.
Replace with new gasket.
*
4-5