To Cancel; To Turn Off; To Resume; Setting The Following Distance In Acc - Dodge Charger SRT 392 2017 Operating Information Manual

NOTE:
ACC cannot be set if there is a stationary vehicle
in front of your vehicle in close proximity.
Remove your foot from the accelerator pedal. If
you do not, the vehicle may continue to accel-
erate beyond the set speed. If this occurs:
• The message "DRIVER OVERRIDE" will ap-
pear in the instrument cluster display.
• The system will not be controlling the distance
between your vehicle and the vehicle ahead.
The vehicle speed will only be determined by the
position of the accelerator pedal.

To Cancel

The following conditions cancel the system:
• The brake pedal is applied.
• The CANC button is pushed.
• An Anti-Lock Brake System (ABS) event
occurs.
• The gear selector is removed from the DRIVE
position.
• The braking temperature exceeds normal
range (overheated).
• The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
• The vehicle parking brake is applied.
• Driver seatbelt is unbuckled at low speeds.
• Driver door is opened at low speeds.
80
• The driver switches ESC to full-off mode.
NOTE:
If your vehicle stays at standstill for longer than
two seconds, then the system will cancel and
the brake force will be ramped-out. The driver
will have to apply the brakes to keep the vehicle
at a standstill.

To Turn Off

The system will turn off and erase the set speed
in memory if:
• The Normal (Fixed Speed) Cruise Control
on/off button is pushed.
• The ignition is turned OFF.
• The Adaptive Cruise Control (ACC) on/off
button is pushed.

To Resume

If there is a set speed in memory, push the RES
(resume) button. Then, remove your foot from
the accelerator pedal. The instrument cluster
display will display the last set speed.
NOTE:
ACC cannot be resumed if there is a stationary
vehicle in-front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
WARNING! (Continued)
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
Setting The Following Distance In
ACC
The specified following distance for ACC can be
set by varying the distance setting between four
bars (longest), three bars (long), two bars (me-
dium) and one bar (short). Using this distance
setting and the vehicle speed, ACC calculates
and sets the distance to the vehicle ahead. This
distance setting displays in the instrument clus-
ter display.
Distance Setting 4 Bars (Longest)
(Continued)