Mounting Display To Subbase; Commissioning Or Service (Using The Mobile Setup Application); Mobile Device Operating System Requirements; Establishing A Direct Wireless Connection To The Smart Hub - Lennox iComfort E30 Installation And Setup Manual

WARNING
DO NOT over-tighten mounting screws. Doing so my distort the subbase
plastic housing and cause connection issues when installed the HD display.
10. Secure subbase to wall with provided #6 x 1.25" pan head screws (4).
11. Connect thermostat wiring to subbase screw terminals.

Mounting Display to Subbase

Install HD Display with UP arrow pointing
up when attaching to subbase.
Rear View of HD Display
1. Hold the HD Display by the edges, line it up with the subbase (horizontal
position), and move the HD Display toward the subbase.
2. Center the cavity on the back of the display over the subbase.
3. Gently press on the edges of the HD Display until you hear the mounting
snaps engage. Be careful not to apply force directly on the glass.
NOTE: Once the HD Display is connected, it may take up to 45 seconds for it
to power up.
4. To remove the HD Display from the subbase, grasp the left and right edges
of the HD Display and gently pull towards yourself.
NOTE: If the HD Display is removed from the subbase base, the HD Display
will shut down and will not be able to communicate with the system.
System can be controlled from mobile devices or consumer/dealer
web portals once registration has been completed.
5. Do not remove the label covering the HD Display screen until after power
is applied to the system.
Commissioning or Service (Using the Mobile Setup
Application)
This application tool is used by dealers to commission a iComfort E30 smart
thermostat using a Wi-Fi enabled mobile device.
A temporary smart hub local network provides a means for a mobile device
using the iComfort Mobile Setup application to directly communicate with the
smart hub.
NOTE: The iComfort Mobile Setup application running on a mobile device
cannot connect to the smart hub through the Internet or home Wi-Fi
network.
To use the iComfort Mobile Setup app, the mobile device must be:
• Wi-Fi capable
• Located in the home near the smart hub
NOTE: A router with Bonjour capabilities is required for this function. Check the
router features if the smart hub does not connect. Apple Bonjour
implementation of Zero-configuration networking (Zeroconf), a group
of technologies that includes service discovery, address assignment,
and host name resolution.

Mobile Device Operating System Requirements

The iComfort Mobile Setup application is available for both IOS 6.0 and higher
(App Store) and Android 4.1 and higher (Google Play).

Establishing a Direct Wireless Connection to the Smart Hub

IMPORTANT
If the connection between the iComfort Mobile Setup application and smart
hub is idle for three (3) minutes, the smart hub will auto-disconnect from the
mobile device. Repeat procedures to reconnect.
1. Download and install the iComfort Mobile Setup application.
2. Apply power to the system. The first screen to appear after boot-up is the
Apple HomeKit commissioning screen. Cancel that screen for now.
NOTE: At this point, it is recommended that when using the iComfort Mobile
Setup application to commission the system, remove the HD Display
from the subbase before starting.
13
is an
®