Service - Lennox iComfort S30 Smart Thermostat Operating, Troubleshooting And Technical Cheat Sheet

8.4. Service

To use Lennox iComfort
ready been completed.
A. Download and install the iComfort
B. Go to the Smart Hub and press the center Lennox button once.
C. The center ring LED will start blinking green for two minutes. During that time the Smart Hub will broadcast its
Wi-Fi identifier (SSID).
D. If this is the first time connecting to the target Smart Hub then go to your mobile device's Wi-Fi connection tool
and locate the Smart Hub Wi-Fi broadcast identifier. The identifier (SSID) is Direct E300-5200 for example. If
your mobile device had already connected previously to the target Smart Hub, then select the applicable Smart
Hub SSID on the list and skip to step F.
NOTE - Refer to your mobile device's owners manual on how to use your Wi-Fi Connection tool.
E. To connect to the Smart Hub use the last eight digits of the Smart Hub SSID as the password (E3005200).
F. Once connected to the mobile device the Smart Hub center ring LED turns solid green.
G. Start the iComfort
the serial number and pushing on the displayed Smart Hub.
H. Press the remote in tab on the iComfort
control center.
I. Once servicing is completed, exit the iComfort
J. Go to the mobile device's Wi-Fi tool and manually disconnect from the Smart Hub.
K. Once disconnected or after three minutes of inactivity the Smart Hub LED turns to a solid blue.
NOTE - If the connection between the iComfort
Smart Hub will auto-disconnect from the mobile device. Repeat entire procedure to reconnect.
®
Mobile Setup Application as a service tool the commissioning of the system must have al­
®
Mobile Setup Application if not already installed.
®
Mobile Setup Application and make sure you connected to the correct Smart hub by checking
®
Mobile Setup Application home screen. This will take you to the dealer
®
Mobile Setup Application.
®
Mobile Setup Application and Smart Hub is idle for 15 minutes, the
- 18 -