Table of Contents
Advertisement
84
Drain water as required
1.
Switch off the machine at the main switch.
2.
Place the collection tray under the drain screw (4).
3.
Loosen the drain screw (4).
4.
Allow water to drain into the collection tray.
5.
Tighten the drain screw (4).
6.
Switch on the machine at the main switch.
10.4 Checking the transport units at the button
feeder
Fig. 39: Checking the transport units
①
(1) - Rotary rubber seal
1.
Check the condition of the transport unit every week. Excess
wear will result in inaccurate button transport, making it nec-
essary to replace the rotary rubber seal (1) and the rubber
seals on the positioning rollers (2).
One set is included in the accessory pack. You can order subse-
quent sets from DÜRKOPP ADLER AG sales offices.
Replacing the rubber seals
1.
Press numeric key 4 on the control panel of the button feeder.
Mechanical system opens.
2.
Loosen and remove the rotary rubber seal (1).
(2) - Rubber seals on positioning
rollers
Instruction manual 550-532 - 00.0 - 07/2015
Maintenance
②
Advertisement
Table of Contents
