Settings via software (sewing automat)
Instruction manual 550-532 - 00.0 - 07/2015
7.8 Bobbin winding
Prerequisite:
• Needle removed.
• Needle thread not threaded.
1.
Press the Ready key.
The key LED illuminates.
2.
Press the Ready key.
The key LED goes out.
3.
Press the Select key until the Bobbin symbol LED illuminates.
4.
Press the Ready key.
The key LED illuminates, the clamp lowers.
5.
Press the pedal forwards.
The bobbin winding process starts.
6.
Press the pedal fully forwards to stop the bobbin winding
process.
7.
Press the Ready key.
The key LED goes out, the clamp raises.
7.9 Counter
The counter can be used as a piece counter (parameter number U020)
or as a counter with an automatic stop (parameter number U076).
Prerequisite:
• Machine is in programming mode, Ready key LED is off.
1.
Press the Select key until the Counter symbol LED
illuminates.
2.
Press the Reset key to set the counter to 0.
3.
Press the +/- Function keys to select the cycle number.
Each end of sewing decrements the counter by 1.
A message is shown on the display when the cycle number
is reached.
4.
Insert a new bobbin.
5.
Press the Reset key.
Counter is reset.
49