70
8.3 Setting button diameter and button height
Fig. 28: Button diameter
(1) - Measurement of button diameter
1.
Make sure there is no button in either of the measuring
devices.
2.
Press numeric key 1.
3.
Insert a button into the measuring device (1) used to measure
the button diameter.
4.
Press numeric key 2.
The measured button diameter is indicated on the display.
The button feeder duct opens.
5.
Remove buttons that are not needed from the button feeder
duct.
6.
Check the button diameter and press numeric key 2 again.
Fig. 29: Button height
(2) - Measurement - button height
7.
Insert another button into the measuring device (2) used to
measure the button height, making sure the device can mea-
sure the entire height of the button (top side of the button
facing down).
Settings via software (button feeder)
Instruction manual 550-532 - 00.0 - 07/2015
①
②