DURKOPP ADLER 550-532 Instruction Manual page 64

Error message Description
E 5 1 1 USB write error
E 5 1 2 USB read error
E 5 1 3 USB write error
E 5 5 0 Data write error
E 5 5 1 Internal process
error
E 7 0 7 Motor signal
7 3 5 error
E 7 3 6 Motor rotation
error
E 7 3 7 Z phase error
E 7 3 8 Z phase error
E 9 0 7 Search error
X axis
E 9 0 8 Search error
Y axis
E 9 1 0 Error
Clamping foot
search
E 9 1 1 Clamping foot
motor error
E 9 1 2 Internal error
62
Settings via software (sewing automat)
Possible cause
File with the same name
already present
Data cannot be loaded from
the USB key
Data cannot be copied to the
USB key.
Flash memory transfer error • Main switch OFF.
Software error
Encoder / motor has no
signal
Motor stops after a certain
time / encoder has no signal
Z signal no longer changes
Z signal inaccurate / encoder
has no signal
X axis sensor not responding • Main switch OFF.
Y axis sensor not responding • Main switch OFF.
Clamping foot sensor not
responding
Clamping foot motor not
running correctly
-
Instruction manual 550-532 - 00.0 - 07/2015
Remedy
• Delete or rename the file.
• Check the USB key.
• Plug in the USB key
again.
• Check the USB key.
• Plug in the USB key
again.
• Repeat the procedure.
• Replace the mainboard.
• Main switch OFF.
• Repeat the procedure.
• Replace the mainboard.
• Replace the software.
• Check the motor /
encoder.
• Check the motor /
encoder.
• Check the motor /
encoder.
• Check the motor /
encoder.
• Check the sensor.
• Check the sensor.
• Main switch OFF.
• Check the sensor.
• Main switch OFF.
• Check the motor and
connections.
• Notify DA Service