Operation of the button feeder
Instruction manual 550-532 - 00.0 - 07/2015
6.3 Adjusting the button separator
6.3.1
Height control
Fig. 13: Adjusting the button separator I
①
②
(1) - Height regulator
(2) - Height control
The height regulator is set such that buttons lying on top of each
other are separated and only single buttons are transported
further.
1.
Loosen the knurled screw (3).
2.
Adjust the height regulator (1) such that the height control (2)
separates buttons that are lying on top of each other:
• Turn the height regulator clockwise: Height control raises
• Turn the height regulator counterclockwise: Height control
lowers
3.
Tighten the knurled screw (3).
③
(3) - Knurled screw
35