Table of Contents
Advertisement
Operation
4.7 Winding the hook thread
The separate winder allows the hook thread to be wound both during
sewing and when the sewing process is stopped.
Fig. 10: Winding the hook thread
(1) - Thread guide plate
(2) - Thread guide channel
(3) - Winding tensioner
To wind the hook thread:
1. Place the thread reel on the reel stand and guide the hook thread
Important
The thread guide must be parallel to the reel stand.
2. Insert the hook thread in a wavelike manner through the two rear holes
3. Feed the hook thread from top to bottom through the thread guide
4. Guide the hook thread counterclockwise around the winding
5. Insert the hook thread in a wavelike manner through the two remaining
6. Feed the hook thread to the winder and clamp it behind the knife (6).
7. Tear off the hook thread.
8. Fit an empty bobbin on the bobbin shaft (5) and turn clockwise until it
Operating Instructions 911-211-10 - 00.0 - 10/2020
①
②
③
through the hole in the guide on the thread guide.
of the thread guide plate (1): From top to bottom through the rear hole
and from bottom to top through the left hole.
channel (2).
tensioner (3).
free holes of the thread guide plate (1): From bottom to top through
the rear hole and from top to bottom through the front hole.
Make sure the thread is NOT under tension.
clicks into place.
(4) - Bobbin winder flap
(5) - Bobbin shaft
(6) - Knife
⑥
⑤
④
25
Advertisement
Table of Contents
