Winding The Bobbin Thread - DURKOPP ADLER 8967 Operating Instructions Manual

3.2 Winding the Bobbin Thread

12
–
Place the bobbin 4 on the bobbin winder 3.
–
Pull the thread through the guide 1 and the tension 2.
–
Wind the thread approx. 5 x clockwise around the
bobbin core and tear off at the thread clamp 6.
–
Press the bobbinr lever 5 into the bobbin.
–
Sewing
The bobbin winder lever stops the procedure when
the bobbin is full.
Attention !
If the thread is not to be wound during sewing, the
pressure foot must be arrested in the raised position and
the pressure foot stroke set at the smallest value.
6
1
2
3
4
5