Warnings - Neopost SA50S User Manual

Error message
WRONG LCA REVISION!
PLEASE UPDATE LCA!
Feed Motor Jammed!
START to continue!
Feed Motor Controller
Fault! Call Service!

9.3.2 Warnings

Warning
Warning:Non-Existant
Font Selected
Position Warning!
Reduce Left Margin!
Macro Too Large Or
Wrong Hor. Position!
Macro ID# In Use
Macro Load Ignored!
MACRO HEIGHT
EXCEEDS 1.5 INCH
Image Height Exceeds
The Maximum Value!
User guide SA50S
Description
Incorrect LCA revision loaded
The paper motor is blocked
Fault in motor control system
Description
Font not in printer
Print area outside print area
Graphics too wide
Macro (same number) already
exists, overwriting not possible
Macro is too high
Print area higher than 38.1mm
NEOPOST Address Printer
Solving the problem
Obtain valid flashware from Support/
Internet and load into the printer
Set paper separator. Replace control
board R0612.1.501.11
Replace control board
R0612.1.501.11
Solving the problem
Examine print image, unlock font
setting in the printer
Check print area outside paper
lenght, reduce left margin on PC, set
OFFSET EDGE to 0
Graphic should alsways be on top
left, max. 101mm wide, then convert
to macro
Delete macro and redefine it
Reduce the height of the graphics by
38.1 mm
No upper margin, set line spacing to
exactly 12 points
46