Neopost SA50S User Manual page 22

The print direction depends on the size of your print medium and of the
upper margin. If the desired margin cannot be reached by the print unit,
then the address block and thus the print medium must be rotated by
180°.
Positioning the address height
The SA50S is a WYSIWYG printer
to the vertical position of the address.
Note the following points regarding your document:
•
In your page layout, set the document to portrait format.
•
Always enter the value 0 for the upper margin.
The last position in the print-out is set by the mechanical position of the
print unit:
•
Place your medium into the printer.
•
Loosen the two knurled screws of the printer unit's cradle.
•
Shift the printer unit so that the nozzle areas of the ink cartridges
come to lie at the desired position.
•
If the nozzle areas cannot reach the required margin, rotate the
medium by 180°. Now position the nozzle area for this situation.
•
Fix the cradle again.
If you have inserted the medium rotated by 180°, you must also rotate
the print orientation by the same amount (Rev):
•
If the printer is not in off-line mode, press the start key and switch
the printer OFF.
•
Press the key, the orientation will be switched over to Rev.
•
Recommendation: Every change should be locked.
Positioning the address width
The width is positioned via the software on the PC:
•
Position the address as required, e.g. with the aid of the left margin
setting, tabulators or other suitable formatting tools.
To ensure that the positioning can be applied correctly to the medium as
specified by the program, the printer must know the exact length of the
medium. This is determined by measurement.
1
) WYSIWYG (What You See Is What You Get)
User Guide SA50S
NEOPOST Address Printer
1
) with some restrictions. These apply
22