Neopost SA50S User Manual page 17

Adjusting the printer to the thickness of the medium
1. Height adjustment of the print unit
To obtain a well-defined print-out, it is important to adjust the height of
the print unit above the print medium. This can only be done when the
cradle of the print unit has been detached:
•
To do this, loosen the two knurled screws of the cradle.
•
For print media up to 0.3 mm in thickness,
the smallest spacing may be used for
printing. Turn the height adjustment control
so that the white dot is right at the bottom of
the knurled screw.
•
For print media with a thickness of 2 mm, the
largest spacing is used for printing. Turn the
height adjustment control so that the white
dot is right at the top of the knurled screw.
•
For print media with a thickness of 1 mm,
turn the height adjustment control to its mid-
position. The white point will then be either to
the right or to the left of the knurled screw.
•
Tighten the two knurled screws of the cradle again. At the same
time, press the cradle lightly downwards so that it lies flush with the
guide.
2. Height adjustment of the two separators
To make sure that only one sheet of print medium is fed in at a time, the
two separators must be set to the thickness of the print medium.
Note:
Both separators must always be adjusted, even in the case that a print
medium of small format lies against only a single separator. If this
condition is not observed, the free separator may drag on the transport
rollers. The wear on these rollers is then increased and feeding may
damage the medium.
User Guide SA50S
NEOPOST Address Printer
17