Neopost SA50S User Manual page 18

•
Loosen the knurled screws of the
two separators.
•
Lift the two separators and place the
print medium under the separator
fingers. If the print medium is
narrow, such as postcards and C10
envelopes, only
fingers may contact it. In this case,
lift the outside separator up to the
top stop and clamp it tight.
•
This step is also recommended if a
separator finger only partially contacts narrow print media, such as
C6 and DL envelopes.
If only three separator fingers contact the print medium, then
another sheet of medium should be placed under the fourth
separator finger. (It may be necessary to remove the outside contact
bracket to do this.)
/ / / /
If these steps are not observed, the separator rollers may
suffer from premature wear.
•
Allow both separators to drop onto the print medium, without
applying any pressur, and then fix the knurled screws again.
Test pattern 1 incorrect
(Excessive pressure on the separator)
The inserted sheet will be ejected by the paper transport mechanism.
Caution! Never touch any internal parts of the printer when it
is running.
•
If the printer is not in off-line mode, press the start key and switch
the printer OFF. If you press the pap key, the print medium will be
ejected. The paper transport is stopped when the pap key is pressed
again.
User Guide SA50S
NEOPOST Address Printer
two separator
Test pattern 2 correct
/ / / /
18